Product Made in Japan
Manufacturer: Okabe
Model: B10-0550

Joint hardware for separators

Size

Features

● Easy on-site adjustment with a wrench.
● No welding required!

◆ Allowable load
●For 5/16 12.0kN (1224kgf)
●For 3/8 18.0kN (1836kgf)
●For 1/2 24.0kN (2447kgf)

Usage instructions

① Insert two separators into the sleeve. (See Fig. A)
② Slide two separators to obtain the necessary length. (Secure at least 30mm for excess length.)
③ Tighten the wedge until its bottom end is inserted further inside than the sleeve bottom surface. See Fig. B [Torque: 3.43kN・cm (350kgf・cm) or more].

Cautions

● Be sure to tighten the wedge until its bottom end is inserted further inside than the sleeve bottom surface
(See Fig. B).
● Separator that cannot be inserted into the sleeve, such as a hat-type separator, can be used by cutting.
● Be sure to use the product within the allowable load or less.