Product Made in Japan
Manufacturer: Okabe
Model: B10-0580

Supporting hardware for ladder formwork

Application

Formwork for staircase with wall

Product specification

Allowable load: 4.90kN （500kgf）

Usage instructions

Installation spacing 900mm or less

Installation method

Cautions

● Install products with spacing of 900mm or less considering the upper formwork weight.
● For installation, use W5/16 plastic cones, bolts or form ties (nuts) to fasten the product at 4 positions.
● Install the product vertically to the formwork.
● Install plastic cones to the no-rib side (see installation method)
● Be sure to place the hexagon head of the bolt in the dent, and screw the bolt into the plastic cone.
● 1 set consists of 1 Ladder Formwork support and 4 hexagon head bolts

◆Notes for using Corner Fastener/Ladder Formwork support
● Note that if screwing lengths of plastic cones and form ties are short, the predetermined strength cannot be secured.
● Check the product for damage etc., before use.
● Do not use the product for any purpose other than its intended purpose.
● When installing the product, confirm its specifications and precautions, and handle it with sufficient care.