liftingProduct made in Japan

Manufacturer: Miki Netsuren

Models: HP-YF

General Introduction

It is a clamp that helps the object being intact without scratches by attach to hard objects and grip them up, such as high tensile strength steel, pressure vessel, stainless steel of steel bridges. It can also be used for lifting work pieces.
If you ever fell stressful because you cannot lift, remove distortion or scratches, intact tension clamp HP-YF can helps you do all those things in the blink of an eye.

Main function

(1) It is the same type with HP-Y, however in fact there is special different design in upper and lower pads that helps the objects are not able to be scratched.

(2) It can be used for multiple purposes depending on individual application such as using chain block, lever block etc.
(3) If the is no load, the hanging ring can easily rotates 360 ° and swings freely in the pulling direction
You should not put excess load to the suspension part.

(4) It can also be used for lifting work (hanging the angle of 60 °).

Note
Although it can be used for lifting work, lifting in the direction shown below is prohibited. (Red arrow direction is strictly prohibited.)

Design