TOYO KEIKI EGP Series DC-Pulse Transducer

Product Made In Japan
Manufacturer: Toyo Keiki
Model: EGP Series

EGP－□ : A signal transducer that outputs a frequency
pulse signal in proportion to analog signals.
Plug-in type makes upkeep and changes in configuration simple.
By using a high-pressure semiconductor relay it is possible to drive a current of AC 200V.
Photo couple provides complete insulation between input and output.

Specification

INPUT	OUTPUT	AUXILIARY POWER SUPPLY
8 standard types of input are available Available with voltage input range DC 0.1mA〜100mA current input range DC10mV〜300V	5 standard types of output are available Available with output range: 0.05〜1000Hz	AC 100/110V ±10% 50/60Hz approx. 3.5 VA AC 200/220V ±10% 50/60Hz approx. 3.5 VA DC 24V ±10% approx. 3 W Types are immediately available. For types not listed above contact a company representative.

INPUT

OUTPUT

AUXILIARY POWER SUPPLY

8 standard types of input are available

Available with
voltage input range
DC 0.1mA〜100mA
current input range
DC10mV〜300V

5 standard types of output are available

Available with output
range: 0.05〜1000Hz

AC 100/110V ±10% 50/60Hz approx. 3.5 VA
AC 200/220V ±10% 50/60Hz approx. 3.5 VA
DC 24V ±10% approx. 3 W

Types are immediately available.
For types not listed above contact a company representative.

TYPE OF OUTPUT SIGNAL	ATTENTION
Two types of output are available • Non-electrical contact output • Electrical pulse output	An output signal of fixed pulse width is generated without regard to the input signal. Output range ceiling values below 10Hz: approx 50mS. Output frange ceiling values over 10Hz: 1/2 the ceiling value cycle. Output cutoff: At an input range lower limit of less than approx.2% output will be shut off. Output protection: Output circuits are equipped with surge absorbers, however, under inductive loading use a device such as a clamp diode or snubber to limit spikes in the current.

TYPE OF OUTPUT SIGNAL

ATTENTION

Two types of output are available
• Non-electrical contact output
• Electrical pulse output

An output signal of fixed pulse width is generated without regard to the input signal.
Output range ceiling values below 10Hz: approx 50mS.
Output frange ceiling values over 10Hz: 1/2 the ceiling value cycle.
Output cutoff: At an input range lower limit of less than approx.2% output will be shut off.
Output protection: Output circuits are equipped with surge absorbers, however, under inductive loading use a device such as a clamp diode or snubber to limit spikes in the current.

Specified Character

(1) Tolerance
±0.5% of output span. (Ambient temperature 23 ℃)
(2) Effect of temperature
Within ±0.5% of output span. (For 23 ℃±10℃ variations)
(3) Effect of auxiliary power supply
Within ±0.25% of output span. (For rated voltage ±10% variations)
(4) Dielectric strength
2000V AC,1min.(50／60Hz)
(Between signal circuit,auxiliary power supply and externel case)
1500V AC,1min.(50／60Hz)
(Between input and output)
(5) Insulation resistance
Higher than 100MΩ at 500V megger.
(Between input,output,auxiliary power supply and external case)
(6) Weight
Approx. 410g