Sakae Tsushin Kogyo
Sakae CP22C Metal Housing Wirewound
Manufacturer: Sakae Tsushin Kogyo Co., Ltd
Model: CP22C
Notes:
- 1 set of inner teeth washer & hex nut is attached.
- Please process the mounting hole on the panel. The diameter should be 10.32 mm (+0.05 / 0).
General Specifications
| Item | Specification |
|---|---|
| Standard Resistance Range | 50, 100, 200, 500, 1k, 2k, 5k, 10k Ω |
| Max. Practical Resistance Value | 20k Ω |
| Total Resistance Tolerance | Standard Class ±3% (H) Precision Class ±1% (F) |
| Independent Linearity Tolerance | Standard Class ±0.5% Precision Class ±0.25% (±0.35% in case of within 1kΩ) |
| Power Rating | 0.5W |
| Noise | Within 100Ω E.N.R. |
| Electrical Travel | 355° ±5° |
| Mechanical Travel | 360° (Endless) |
| Insulation Resistance | Over 1,000MΩ at 1,000V D.C. |
| Dielectric Strength | 1 minute at 1,000V A.C. |
| Starting Torque | Within 5mN·m (50gf·cm) |
| Resistance Temperature Coefficient | ±20 p.p.m./°C |
| Mass | Approx. 23g |
Standard Resistance Values / No. of Wire Turns / Resistance Wire Used
| Resist. Value (Ω) | 50 | 100 | 200 | 500 | 1k | 2k | 5k | 10k | ※20k |
|---|---|---|---|---|---|---|---|---|---|
| No. of Wire Turns | 300 | 370 | 470 | 450 | 570 | 740 | 1,000 | 1,270 | 1,670 |
| Resist. Wire Used | Cu-Ni | Cu-Ni | Cu-Ni | Ni-Cr | Ni-Cr | Ni-Cr | Ni-Cr | Ni-Cr | Ni-Cr |
Note: Mark ※ shows special high resistance value.
Special Specifications Available
| Available Options |
|---|
| Lower resistance values (10Ω, 20Ω) |
| Extra tap (Available up to 1 tap) |
| Shaft with front and rear extension (Rear shaft with 3mm dia. and 20mm length) |
| With stopper (Rotating angle is 320° and stopper strength is 0.9N·m [9kgf·cm]) |
| Special electrical travel |
| Shaft dia. (φ6.35mm) & bushing with inch dimension |
| Special machining on the shaft |
REQUEST QUOTATION
PAYMENT
LINK
