Product Made in Japan
Manufacturer: Flex System
Model: TL

You can use it by pushing in and rotate it 90 ° to finish fixing.
This is a very convenient item because it takes less time than the screw type.
The inserts can be easily attached to and removed from the formwork, saving labor and time.

Using Example

How to use

* How to attach the hanger.

Push the hanger to the bottom of the insert, and if the blue part of the bar is visible in the shackle, hold the handle and turn 90 degrees to the right.

Rotate. Please confirm that the lock is applied.

Then, slightly turn the resin nut to the right. The insertion position of the jig is fixed.

Please note that if you tighten it too much, it may not be possible to reverse it.

* How to remove the hanger.

Reverse procedure, turn the resin nut to the left to loosen, push the handle and rotate 90 degrees to the left to unlock,

Remove the hanger.

Product details

Maximum lifting load (2 points hanging)

Model		Total length (mm)		Inversion	Quantity
TL20 x 50		50 (-70)		1200 kg	500 pieces
TL20 x 60		60 (～ 80)		1340 kg
TL20 x 70		70 (up to 90)		1720 kg
TL20 x 80		80 (up to 100)		2140 kg	550 pieces
TL20 x 90		90 (-110)		2320 kg	500 pieces
TL20 x 100		100 (-120)		2320 kg

* The total length can be adjusted with the slide cap.

TL suspension	Color
For TL20 x 50/60	Red
For TL20 x 70/80	yellow
For TL20 x 90/100	White

 

TL cap

Quantity

1000 pieces

 

TL mounting jig	length	Mounting screw
For hinge release	9 mm	M6
For slide demolding	15 mm	M6