The T4PM Plus is a T4PM that allows you to enjoy the response of T-FHSS SR communication at a reasonable price, and now comes with a new slot dedicated to the MINI-Z module (FS-RM005 (Note 1)).

This mid-range radio is packed with features, expanding the range of play possibilities while also inheriting the popular wireless servo, gyro, and ESC settings (Note 2).

*Note 1: The MINI-Z module requires the FS-RM005 module (Kyosho Corporation).
*Note 2: Wireless settings are supported by the R334SBS series receiver.

• Direct control with T-FHSS SR and SR-mode servos: The transmitter pairs T-FHSS SR with SR-mode servos to deliver quicker, more connected response than conventional digital servos; moreover, you set the link system and servo mode (SR/digital, etc.) on the receiver settings screen, and you configure telemetry there as well.

Telemetry can only be used in T-FHSS mode. It cannot be used in other modes (T-FHSS SR, S-FHSS, MINI-Z series).

• Edit section: Each function can be easily accessed using the jog switch.
  
• Micro SD card slot: Used for software updates. (Micro SD card sold separately. Supports SD/SDHC, not SDXC.)
  Switch: Can be operated with the left hand while holding the handle.

• Trigger slide: The position of the throttle trigger can be moved forward and backward (7mm), allowing it to fit perfectly to any hand size.
  
• Design registered
  Battery Requirement: Requires four AA batteries (rechargeable batteries are also available separately).

Functions & Specifications

Setup

• Receiver settings: Select T-FHSS, T-FHSS SR, S-FHSS, MINI-Z EVO, MINI-Z EVO2, or the MINI-Z module FS-RM005. For a full receiver-compatibility list, check the receiver guide.

• Speed: Slow a servo that feels too fast—or, conversely, speed it up when you want a sharper feel.

• Acceleration: Tune servo ramp near neutral separately for throttle and brake sides to smooth initial response.

• TH ABS: Use ABS to reduce brake lock when grip falls off.

• TH mode: Choose 5:5 or 7:3, then set idle-up, neutral brake, engine cut, and more.

• Traction: Adjust on-throttle traction while cornering for a calmer exit or a livelier rotation.

• CH3 / CH4: Position third- and fourth-channel outputs where you want them.

• Start: Configure start-related behavior to match your launch style.

• Core tuning: EXP, End Point (EPA), Sub-trim, Reverse, D/R, ATL, and Fail-Safe give you full control.

Model Menu

Select, name, copy, reset, transfer, and delete models; in short, manage your entire garage from the radio.

Mixing

• STR MIX: Drive twin steering servos in sync for stronger, more consistent steering.

• Brake MIX: Balance separate front and rear brake servos.

• Gyro MIX: Adjust Futaba gyro sensitivity directly from the radio.

• 4WS: Control front and rear steering with individual servos for true four-wheel steer.

• Dual ESC: Run front and rear ESCs independently and coordinate them precisely.

• CPS MIX: When you add CPS-1 (optional), set LED patterns and lighting behavior.

• Tank MIX: Control tracked vehicles smoothly and intuitively.

• PROG MIX (1–2): Mix any channels to solve specific handling goals; for example:

  • make the car rotate harder under braking → reduce gyro gain only while braking,

  • stabilize acceleration → increase gyro gain when throttle is ON,

  • cut straight-line hunting → lower gyro gain near steering neutral.

• Switch settings: Map your favorite functions to two hardware switches.

• Trim/Dial assign: Assign functions to five digital trims and one rotary dial for fast adjustments.

Accessories & Links

• S.BUS Servo: Connect servos to the COM port and set S.BUS/S.BUS2 parameters right from the transmitter.

• MC Link: Connect a Futaba ESC to the COM port and change settings; moreover, configure MC971CR / MC970CR wirelessly. (For other supported models and any feature limits, see the manual, p. 91.)

• Gyro Link: Configure gyros for Panasonic car models from the transmitter; in some cases, you can even do it wirelessly. (For supported models and limits, see the manual, p. 108.)

• Timer & Lap List: Track runs and compare pace effortlessly.

• Telemetry: Set up telemetry when you run T-FHSS mode. (Telemetry does not operate in T-FHSS SR or S-FHSS.)

• Log Data: Save telemetry logs to the transmitter for later review.

• Index table (DD cars) & Gear-ratio table: Reference gearing quickly and keep setups consistent.

• Adjuster: Calibrate inputs so the sticks and dials read perfectly.

Included Accessories

• Mini screwdriver ×1

• Hex wrenches 1.5 mm and 2.0 mm (one each)

• 4P-SQ transmitter battery box ×1 (installed in the transmitter)

• Instruction manual ×1

Optional Parts

• Transmitter LiFe batteries: FT2F1100B (6.6 V / 1100 mAh), FT2F1700B V2 (6.6 V / 1700 mAh), FT2F2100B V2 (6.6 V / 2100 mAh)

• Recommended chargers: LBC-34D(P) and LBC-4E5

• Carbon handle

• DSC cable (for model transfer)

• Various wheel sets

• ICS LF-01 contactless charger

• Telemetry sensors: available separately

• Neck strap
  Note: the carbon handle shown in some photos is an optional accessory.