Koganei MRG With Guide

Manufacturer: KOGANEI CORPORATION

Features

MRG (With guide)

1. Durability is increased, and guides have been used to enable heavy load capacity.
The load, which is applied to the cylinder tube, is distributed to 2 guide shafts.
A heavy load capacity (490.3N [110.2 lbf.] or less for φ40 [1.575 in.]) and a large allowable moment are obtained.

2. The stroke can be finely adjusted.
The stroke can be finely adjusted with the stroke adjusting bolt within the range of +1〜−6 mm [+0.039〜−0.236 in.] for one side.

3. It is possible to install a double rod type shock absorber.
A double rod type shock absorber which can be installed in the slider is optional.
With multi-orifice type operation, which needs no adjustment, the shock is smoothly absorbed.

4. Concentrated piping on one side
Concentrated piping on one side is possible on the end surface or the side as shown in the diagram to the right.
Moreover, the piping location can be selected according to installation requirements because there are many connection ports.

5. Sensor switches can be used.
The magnet for the sensor switch and the mounting rail are standard equipment.
Many kinds of small-sized sensor switches can be attached.

Specifications

Item	Bore size mm [in.]	6 [0.236]	10 [0.394]	16 [0.630]	20 [0.787]	25 [0.984]
Operation type		Double acting type
Media		Air
Operating pressure range MPa [psi.]	H type	0.25～0.7 [36～102]	—	0.2～0.7 [29～102]
Operating pressure range MPa [psi.]	L type	—	—	0.18～0.34 [26～49]
Proof pressure MPa [psi.]		1.03 [149]
Operating temperature range °C [°F]		0～60 [32～140]
Operating speed range mm/s [in./sec.]		100～500 [3.9～19.7]
Cushion		Rubber bumper
Lubrication		Not required
Stroke adjusting range mm [in.]		+1～−6 [＋0.039～−0.236] (One side) (Fine adjustment at the end of the stroke only)		0～−10 [0～−0.394]
Stroke tolerance mm [in.]	1000 or less	+1.5 [+0.059] / 0 / 0
Stroke tolerance mm [in.]	1001～1500	+2.0 [+0.079] / 0 / 0
Port size		M5 × 0.8			Rc1/8	Rc1/4