Features

The upgraded TXS Series PE chemical dosing tanks are compact units compatible with Tohkemy and ProMinent electromagnetic pulse pumps. Available in three sizes: Type 25, 50, and 100.
Higher Capacity: +20% capacity increase simplifies chemical replenishment (e.g., Type 50 holds three 18L cans).
Enhanced Usability: Includes standard liquid level gauge, level switch seat, and liquid return seat—no post-processing needed.
Dual-Pump Mounting: Supports mounting up to two pumps (Types 50 & 100).
Secure Mounting: Integrated mounting feet (3 points on Type 25; 4 points on Types 50 & 100).
Safety Design: Light-resistant black lid with padlock compatibility; sloped top prevents chemical spills over front equipment.
Optional Accessories
Front cover & padlock
Liquid level gauge with isolation valve
Level switches (Tohkemy FS or TL types)
Custom electrical control panel

Specification

Model	Material	capacity	mass	Mountable pump
TXS-25	PE	30L	about 7kg	MP-L _and CM-1 to 25V type pump * Prominent electromagnetic pulse pump (Beta _and gamma type) * CM-V type can be installed only on TXS-50 / 100
TXS-50		60L	about 12kg
TXS-100		120L	about 18kg

Technicians must position the chemical tank out of direct sunlight and verify that ambient and process fluid temperatures remain strictly between 0 and 40 °C during operation.
The specific gravity of the liquid should be 1.3 _or less.
Operators must not process off-gassing or vapor-emitting fluids—such as hydrochloric acid—to prevent gas entrapment, vapor locking, and system overpressurization.
See also PVC / PE tanks.

Tank dimensions

	unit：mm
	Model	A	B	C
	TXS-25	430	465	(515)
	TXS-50	560	465	(670)
	TXS-100	560	575	(805)

System flow

Basic system
This is the most basic _system for injecting medicine simply by supplying power using an electromagnetic pump.
_System with flow monitor _and level switch
This _system adds an optional flow monitor to the MPX type pump that can be directly connected to the level switch to detect defective discharge of chemicals. The specification to stop the pump when the tank is low level can be selected, _and an alarm signal can be output to the outside when the tank is low level _or the chemical discharge is poor.
Chemical injection _system with conductivity meter
The MPX type pump is controlled by the conductivity meter in a system in which a panel with a built-in conductivity meter is attached to the side of the chemical injection tank. Ideal for supplying liquid fertilizer in hydroponics. In addition to the conductivity meter, a 24-hour cycle time switch can also be built into the panel. In the cooling tower _system, the blow valve is controlled by the conductivity meter, _and the MP type pump is turned on _and off by the time switch for chemical injection. You can also.