Drilling And Cutting, Japan, Unika
UNIKA SC Stainless Steel Rooty Anchor
Manufacturer: UNIKA
Model: SC type mm size (Stainless)/ SC type Inch size (stainless)
■Simply hammer in the pin. Just by looking at the pin, completion of anchor can be confirmed.
■Screw diameter and anchor unit diameter are the same, allowing use in small drill bores.
■SC type is all stainless steel, making it highly corrosion resistant. Wide applications in high humidity locations.
| Thread dia | Tightening Torque |
|---|---|
| M6 | 5 N・m |
| M8 | 12 N・m |
| M10, W3/8 | 24 N・m |
| M12, W1/2 | 42 N・m |
| M16 | 100 N・m |
| M20 | 200 N・m |
USES
Concrete
- Drill preparation hole.
- Position anchor.
- Strike pin with hammer.
- Anchor attached with open lags.
■Installation explanatory video
■Uses
Suited for all kinds of fixture attachments including construction, electrical, sanitation, airconditioning/heating, signboard attachment, seat attachment, and machine installation works.
■Structural Drawing
■Use Examples
- Protective clothing including safety glasses and helmets must always be worm when installing.
- Drill perpendicularly into target surface.
- Compared with anchor insertion depth, drill holes should be 5mm deeper for M6, M8, M10; 7mm deeper for M12; 10mm deeper for M16; 15mm deeper for M20.
- Drilling preparation holes too shallow will break or bend core rods.
- Use blower throughly.
- Always set nut before hammering.
- Use a hammer appropriate for the anchor size.
- JCAA Product Certification Mark
- Products with this certification mark satisfy the evaluation and certification standards specified
by the Japan Construction Anchor Association (JCAA).
SPECIFICATION
SC type mm size (Stainless)
| Size | Dia (outside diameter) | Size | Dia (outside diameter) |
| SC-645 | M6 | SC-1260 | M12 |
| SC-660 | SC-1270* | ||
| SC-840 | M8 | SC-1280 | |
| SC-850* | SC-1290* | ||
| SC-870* | SC-1210* | ||
| SC-890* | SC-1212* | ||
| SC-810 | SC-1215* | ||
| SC-1050 | M10 | SC-1680 | M16 |
| SC-1060* | SC-1610* | ||
| SC-1070 | SC-1612* | ||
| SC-1080* | SC-1615* | ||
| SC-1090* | SC-1619* | ||
| SC-1010* | SC-2013* | M20 | |
| SC-1012* | SC-2015* | ||
| SC-1015 | SC-2019* |
*JCAA certified product
*Special dimensions for both C and SC types can be produced to order.
SC type Inch size (stainless)
*JCAA certified product
*Special dimensions for both C and SC types can be produced to order.
*Maximum extraction strength values are values measured by UNIKA and not standard values.
