Japan, Kyowa Electronic Instruments Co., Ltd.
Kyowa PSS-1KAE Miniature Pressure Sensor
Made in Japan
Manufacturer: Kyowa Electronic Instruments Co., Ltd.
Model: PSS-1KAE
The PSS is a miniature pressure sensor with a strain-gage bridge inside. Thin-film strain gages are directly formed on the diaphragm.
Features
- Ultra-thin
- Installed by adhesives
- Suitable for distributed pressure measurement by using multiple units
Specifications
Performance
Rated Capacity | 100 kPa |
---|---|
Nonlinearity | Within ±1% RO |
Hysteresis | Within ±1% RO |
Repeatability | 0.5% or less |
Rated Output | 1 mV/V or more Note: Rated output is sorted to one of the classes divided by every 2% difference in output value. Since the rated output stated in the Test Data Sheet is the center value of the class, it may have a maximum error of ±1%. |
Cable Direction to Sensing Surface | Horizontal |
Environmental Characteristics
Safe Temperature | -20 to 70ºC (Non-condensing) |
---|---|
Compensated Temperature | 0 to 50ºC (Non-condensing) |
Temperature Effect on Zero | Within ±0.8% RO/ºC |
Temperature Effect on Output | Within ±0.3%/ºC |
Electrical Characteristics
Safe Excitation | 4 V AC or DC |
---|---|
Recommended Excitation | 1 to 2 V AC or DC |
Input Resistance | 350 to 1000 Ω |
Output Resistance | 350 to 1000 Ω |
Initial Unbalance | Within 2.5 mV/V (5000 ×10-6 strain) |
Cable | Polyurethane coated copper wires, 0.08 mm diameter by 5 cm long, bared at the tip |
Mechanical Properties
Safe Overloads | 150% |
---|---|
Natural Frequencies | Approx. 31 kHz |
Weight | Approx. 0.15 g (Excluding cable) |
Dedicated Adhesive | RC-19 (Request the RC-19 when ordering the transducer.Cost option) |
Dimensions
To Ensure Safe Usage
High-carrier-based dynamic strain amplifier DPM-912,913 or 952 may not satisfy the specified rated output insome rare case.
Use dynamic strain amplifier DPM-911,951, signal conditioner CDV-900A or request us to
calibrate the transducer in combination with the strain amplifier.
Remarks
(Note 1) Use copper alloy for the liquid-contacting part.
Avoid measuring corrosive liquid or gas.
(Note 2) Assemble the liquid-contacting part using an epoxy adhesive.
Therefore, refrain from using the sensor to measure organic solvents (Toluene, ketone, etc.).
(Note 3) Avoid prolonged use under high temperature and high humidity environments.
(Note 4) Avoid submerging the sensor underwater.
Related Products
-
Yutani FTU/FTA Fastening Torque Analyzer (Electronic Control System)
-
Super Tool RND1719/1721 Quick Turn Ratchet Wrench Double Size (With Bent Spear)
-
TONE BJ30 Ball Joint
-
Chiyoda Seiki Strong-25 Cutting Machine – Lever Type For Cutting Medium To Heavy Materials (Per 3 steps)
-
SAKUSAKU RFSS-35D 12.0 Carbide Roughing End Mill 4 Flute
-
Nippon Hoist NHEC Standard Hoist With EC Trolley