Japan
CA-7/CB-10 Moil Point Chisel For Air Breaker/Pick Hammer

Product Made in Japan
Model: CA-7, CB-10
Shape: Moil Point
Application of Moil Point
Please use this for road pavement, concrete structures, and crushing foundations.
Specifications of Moil Point
MODEL | Shank size(mm) | Full length(mm) | Shape |
CB-10 | R26×80 | 400 450 600 800 1000 1200 | Moil Point Straight Asphalt Cutter 75(kin) Spade Cutter 100(kin) / 140(kin) ※No spring Wedges and Shims 32φ × 450L / 600L |
CA-7 | R26×80 | 400 450 600 800 1000 1200 | Moil Point Straight Asphalt Cutter 75(kin) Spade Cutter 100(kin) / 140(kin) ※TCA7 With spring Wedges and Shims 32φ × 450L / 600L |
To use your chisel as long as possible, please do the following
- Inspect your chisel before each use.
- Lubricate your chisel properly.
- Warm up your chisel when it is cold outside.
- When you hear a strange sound, stop using your chisel immediately.
Safety precautions when using Moil Point
- Please wear protective safety equipment such as shoes, gloves, a cap and glasses.
- Please post the safety instructions for the proper use of the chisel in a visible place.
- In the case of chisel repair, make sure not to decrease the durability, hardness and performance characteristics of the chisel.
- When you attach or remove your chisel, make sure that no one gets hurt or nothing is damaged during the procedure.
Related Products
-
MISUZU Apparel Paper
-
Chiyoda Seiki TKR-170HS/TKR-170HS-H/MR-170HS/MR-170HS-H (Primary pressure: 20.0 MPa or less/adjustment pressure 2.0 to 12.0 MPa)
-
Eagle Clamp SCC Type Chain with Clamp
-
Chiyoda Seiki MCHP-100A Semi-automatic Switching Gas Supply Device Stand Set (standard flow rate: 50ℓ/min・Air)
-
Tokyo Sokushin VSE-355JE Servo Velocity-meter
-
NMC HYP-FH1 Small Hole EDM Dielectric Fluid