Japan
DIG-9 Chisels For Air Breaker/Pick Hammer

Product Made in Japan
Model: DIG-9
Application
Please use this for road pavement, concrete structures, and crushing foundations.
Specifications of DIG-9
MODEL | Shank size(mm) | Full length(mm) | Diameter | Shape |
DIG-9 | 31.7H×152 (1-1/4×6) | 530 600 | 28φ | Moil Point Straight |
To use your chisel as long as possible, please do the following
- Inspect your chisel before each use.
- Lubricate your chisel properly.
- Warm up your chisel when it is cold outside.
- When you hear a strange sound, stop using your chisel immediately.
Safety precautions when using DIG-9
- Please wear protective safety equipment such as shoes, gloves, a cap and glasses.
- Please post the safety instructions for the proper use of the chisel in a visible place.
- In the case of chisel repair, make sure not to decrease the durability, hardness and performance characteristics of the chisel.
- When you attach or remove your chisel, make sure that no one gets hurt or nothing is damaged during the procedure.
Related Products
-
Ebara CM Centrifugal Pumps
-
Kunimoto 1301320 KS U-shaped Clamp Type 3
-
Murata Self-supporting small needle 12021-F
-
TERAOKA SEISAKUSHO 760H #25 Double-coated Adhesive Kapton(R) Film Tape
-
Chiyoda Seiki SGX-40 Small/Medium/Large flow/Pressure regulator/Governor Small/medium/large flow Rate Governor (primary pressure: 1.0 to 35.0 kPa/set pressure 0.5 to 20.0 kPa)
-
Eagle Jack (Konno Corporation) MM200-30 Holding Block