Made in Japan
Manufacturer: Kyowa Electronic Instruments Co., Ltd.
Model: LUX-B-50N-ID
The LUX-B-ID is a compact stainless-steel load cell with waterproof connector for measuring tension or compression loads. Models for withstand to repeated bending (Flexible cable) are available.
Features
• High sensitivity
• Easy installation
• TEDS installed
Specifications
Performance
Rated Capacity
±50 N
Nonlinearity
Within ±0.15% RO
Hysteresis
Within ±0.15% RO
Repeatability
0.05% RO or less
Rated Output
0.85 mV/V or more
Environmental Characteristics
Safe Temperature
-20 to 80ºC
Compensated Temperature
-10 to 70ºC
Temperature Effect on Zero
Within ±0.03% RO/ºC
Temperature Effect on Output
Within ±0.005%/ºC
Electrical Characteristics
Safe Excitation
10 V AC or DC
Recommended Excitation
1 to 5 V AC or DC
Input Resistance
375 Ω ±1.5%
Output Resistance
350 Ω ±1%
Dedicated Connection Cable
TE-45
Cable
6-conductor (0.08 mm2) chloroprene shielded cable, 4.4 mm diameter by 3 m long
Sensor side: Terminated with a connector plug 213FCW-8P
Measuring instrument side: Bared at the tip
(Shield wire is not connected to the case.)
Mechanical Properties
Safe Overloads
150%
Natural Frequencies
Approx. 8 kHz
Recommended Tightening Torque
Approx. 3 N·m
Materials
SUS (Metallic finish)
Weight
Approx. 50 g (Excluding cable)
Degree of Protection
IP67 (IEC 60529)
Optional Accessories
Mount base CX
Ball joint TU
Whirl-stop coupling TSC
Whirl-stop brackets TS
Dimensions
Mount Base
CX-2
Object Product Model
LUX-B-50N-ID
LUX-B-100N-ID
LUX-B-200N-ID
Weight (Approx.)
40 g
Whirl-stop Couplings
TSC-2F
Object Product Model
LUX-B-50N-ID
LUX-B-100N-ID
LUX-B-200N-ID
TSC-2M
Object Product Model
LUX-B-50N-ID
LUX-B-100N-ID
LUX-B-200N-ID
Whirl-stop Brackets
TS-2
Object Product Model
LUX-B-50N-ID
LUX-B-100N-ID
LUX-B-200N-ID
Ball Joint
TU-6B
Object Product Model
LUX-B-50 to 200N-ID
Weight (Approx.)
25 g
To Ensure Safe Usage
If impacts are expected in receiving tension loads, select a load cell with the rated capacity higher by one rank than the operating load.
Pay attention to strength of fastened parts which is screwed into the LUX-B.
When using the LUX-B with rated capacity more than 2 kN or more, use the fastened parts made of a material with tension strength more than 800 N/mm2.
Typical recommended material: SUS630 (H900) HRC40 to 47, SCM435 HRC30 to 38
For tensile load measurement, take care never to exceed the safe overload rating.