Japan, Kyowa Electronic Instruments Co., Ltd.
Kyowa PI-32heat-cured Glue
Made in Japan
Manufacturer: Kyowa Electronic Instruments Co., Ltd.
Model: PI-32heat-cured
In order to obtain good measurement data, the strain gauge must be fully bonded to the material under measure.
It is important to choose and use an adhesive that is suitable for the material to be measured, the material of the gauge base, and the measurement conditions.
*This is an external site.
Specification
type | heat-curing |
---|---|
Operating temperature range | -269~350 |
Main applicable materials | ・Metals (iron, stainless steel, copper, aluminum alloy, etc.) |
Hardening conditions | ・Heated at 200°C for 500 hour in pressurized state (100~1kPa) →200°C for 2 hours → Aging by removing the pressurization*1*1Put the object to be measured in a heating furnace etc. and perform the following aging. (The temperature rise rate shall be about 5°C/min.) In the case of KFU gauge Rise from room temperature to 300°C… Hold for 2 hours for KFHB gauge to raise the temperature from room temperature to 250°C… Hold for 2 hours * If heating at 200°C is difficult, change 200 hours at 2°C to 160 hours at 5°C, and perform the rest under the same conditions. |
classification | Polyimide 1-component , heating type |
capacity | 20g |
forte | ・Suitable for bonding strain gauges in strain measurement up to high temperature ranges. |
Main applicable gauges | KFU KFHB |
Remarks
Note: The operating temperature range is the adhesive itself and varies depending on the combination with the gauge. Before use, please read the attached instruction manual carefully before use.