Japan, LOBTEX
LOBTEX SD5S Swaging Die Set
Made in Japan
Manufacturer: LOBTEX CO., LTD.
Model: SD5S
Set of dies for manual hydraulic flaring/swaging tools
Use/Application
Specifications
| Model No. | Set details | Use range | Retail/User prices |
|---|---|---|---|
| SD5S | for swaging die SD20（1/4″）SD30(3/8″)SD40(1/2″)SD50(5/8″)SD60(3/4″)Set plate | （for Copper pipe）1/4″・3/8″・1/2″・5/8″・3/4″ | open price |
IMPORTANT SAFETY INSTRUCTIONS
Before work, remove burrs from the pipe cut surface. If deburring is insufficient, inadequate processing may result. Remove burrs completely.
Tighten the gauge securely using the shaft included with the tool. If tightening is insufficient, the desired work surface may not be obtained.
Make sure that the gauge securely fits in the groove of the body yoke. If the gauge does not completely fit in the groove, it may come off during work.
CAUTIONS ON INSCRIBED VALUES
Since dimensions, weights, etc. are nominal, there possibly are changes of some numerical values.
Specifications may be changed for improvement of the product without prior notices.
Listed prices do not include VAT. Please ask our distributor in case of purchases.
Related Products
-
Eisen EM(-) Series Pin Gauge
-
UHT Corporation Pin For Air Mirco Grinder
-
IMADA LM series Coin Shaped Load Cell
-
Fuji Tool Mini-Magnetic Stand
-
UHT Corporation PZ-DESK Series Pilot Hole Punching Machine
-
Chiyoda Seiki MBO-25/MBN-25 Anesthesia Pressure Regulator For Oxygen And For Laughing Gas (primary pressure: 15.0 MPa or less/set pressure 0.4 MPa, standard flow rate: 25 ℓ/min)
