Okabe A30-0020 Pipe Holder Cup

Product Made in Japan
Manufacturer: Okabe
Model: A30-0020

Holder cup for steel pipe or scaffolding frame

Spece

A30-0020

H200H300H500
minmaxminmaxminmax
Dimensions of each partH170240230360340580
H130200190320300540
A95155265
B130190300
PackingCaseCaseCase
Quantity10 units10 units10 units
Weight (Package)9.8kg11.4kg14.3kg

Application

To receive steel pipe or scaffolding frame to place pressure resisting board

How to use

In case the cup is removed ⚠️                                                                            In case the cup is embedded

A30-0020

Cautions

  • Use the product within the allowable load of 4.90kN・cm (500kgf・cm). Make the load act vertically.
    (Horizontal load is not taken into consideration.)
  • The numerical value of the allowable load is the strength of this product.
  • Do not use the product under horizontal load.
  • After adjusting the height, be sure to tighten the locknut.
  • After adjusting the height, be sure to set the waterstop ring in the middle between the cup lower end and the locknut.
  • Be sure to place the pipe in the center of the cup.
  • Be sure to secure the baseplate with four concrete nails, and use the product within the applicable height mentioned above.
  • When the cup is removed, lower the waterstop ring near the locknut and cure the bolt part before placing concrete.

REQUEST QUOTATION

PAYMENT

payment-methods

Return Top