TB Prepair Agents, Two-component epoxy-compound resin

ThreeBond TB Prepair Agents, Two-component epoxy-compound resin

Products Made In Japan
Manufacturer: ThreeBond
Model: TB

Model	Purpose	Picture
TB2081D	This adhesive is a set with a main agent and a curing agent. It has excellent adhesion strength for soft PVC, which is difficult to bond. It is good for bonding with rubber such as CR and EPDM and various metals.
TB2082F	This is an adhesive filling repair agent for metals that uses epoxy resin as the main component. After curing, it forms a tough cured material resembling iron, enabling machining to be done. This agent is used in a 10:1 mixing ratio of main agent to curing agent.
TB2087	This is a two-component epoxy-compound resin that uses epoxy resin as the main component and can cure at room temperature. It has excellent elasticity and toughness and a particularly high peel strength.
TB2082C	This high-strength adhesive is a set with a main agent and curing agent. Rubber particles are distributed, so it forms a tough cured material. It is good for bonding a wide range of materials such as various metals and plastics.
TB2083L	This is a putty type water-curing two-component epoxy-compound resin that uses epoxy resin as the main component. It has excellent adhesion strength even on wet surfaces and in water. ( tested for leaching performance in water supply equipment according to JIS S 3200-7)
TB2088E	This heat-resistant adhesive is a set with a main agent and curing agent. It has excellent adhesion even at 200 degrees C (approximately). It is good for bonding various metals and ceramics.
TB2082E	This is a general adhesive filling repair agent that uses epoxy resin as the main component. It has excellent chemical resistance, water resistance, and oil resistance.
TB2086M	This fast-curing low temperature type adhesive is a set with a main agent and curing agent. It can even cure at a low temperature of -5°C. It is good for bonding various metals, plastics, and rubber, etc. (There is a tube type available)