Japan, Tokyo Ko-on Denpa
Tokyo Ko-on Denpa 45LT-R2 Series Input, Cross Fader
Made in Japan
Manufacturer: Tokyo Ko-on Denpa Co., Ltd.
Model: 45LT-R2 Series
Features
Direct print resistor element used (Special surface treatment).
Equipped with a torque adjustment mechanism with good feel.
Horizontal style control-bar design.
Durable system which adopted the shaft of the high quality.
Connector terminal style.
Electrical Specifications (Initial Value)
| Electrical specifications (initial value) | 45LT-R2 Series |
|---|---|
| Products | 45LT-R2-CN0-B* |
| Number of circuits / Type of output laws | 1 Linear taper |
| Circuit method | Potentiometer circuit |
| Total resistance (1-2), (6-4) | 10kohm, 50kohm |
| Total resistance tolerance | ±20% |
| Absolute linearity | ±5% |
| Residual resistance (1-3), (1-4) | 60ohm or less |
| Voltage proof | 1 Min. at AC100V |
| Insulation resistance | 50Mohm or more at DC250V |
| Max rating | 0.1W |
| Maximum input voltage | DC30V or less |
| Rated Resistive Load – Switch | AC125V 3A, DC30V 2A (OMRON D2F-F) |
| Sliding noise level | 47mV or less (by JIS C 6443) |
| Sliding life | 100,000 Cycles Min. (18cycles/min, Sliding noise level: Less than 100mV) |
| Connector (4pin) | B4B-EH (EH Series: J.S.T.MFG.CO.,LTD.) |
Mechanical Specifications (Initial Value)
| Mechanical specifications (Initial value) | 45LT-R2 Series |
|---|---|
| Travel (Stroke) length | 44mm ±0.5mm |
| Operating force | 0 to 0.1N 0 to 0.5N (Torque adjustment screw) |
| Strength Nut-Attached | 100Ncm |
| Attached parts | M3 screw (Length: Panel thickness + 3mm) |
| Stopper strength | 50N |
| Push-pull strength | 50N |
| Alignment to the center | ±0.5mm (State not to pressure control-bar, Measurement position: Mounting surface) |
General Specifications
| General specifications | 45LT-R2 Series |
|---|---|
| Temperature range | -10 to +60 degrees C (Operating), -15 to +65 degrees C (Storage) |
| Relative humidity | 80%RH (No condensation) |
