,

Tokyo Ko-on Denpa LSVA Series Manual Control Fader

Made in Japan
Manufacturer: Tokyo Ko-on Denpa Co., Ltd.
Model: LSVA Series

Features

Direct print resistor element used (Special surface treatment).
Vertical style control-bar design. PCB Terminal style.

LSVA Series

Electrical Specifications (Initial Value)

Electrical specifications (initial value)LSVA Series
ProductsLSVA-*****-B*2LSVA-*****-B*LSVA-*****-*2LSVA-*****-*
Number of circuits / Type of output laws1
Linear taper
2
Linear taper x2
1
Audio taper
2
Audio taper x2
Circuit methodPotentiometer circuitLadder circuit
Total resistance (1-3)10kohm, 5kohm
Total resistance tolerance±20%
Absolute linearity±5%
(The travel is divided into 10 sections and 11 positions are measured.)
Residual voltage (1-2), (2-3)20mV or less-
Residual resistance (1-2), (2-3)50ohm or less
Attenuation accuracy [Load: high]0 – 20dB: ±3.0dB
Matching accuracy0 – 20dB: 3.0dB
Insertion loss0.5dB or less
Cut off [15kHz]95dB Min.
Voltage proof1 Min. at AC500V
Insulation resistance50Mohm or more at DC250V
Max rating0.2W (Linear taper), 0.1W (Other taper)
Maximum input voltageDC30V or less
Sliding noise level47mV or less (by JIS C 6443)
Sliding life100,000 Cycles Min. (18cycles/min, Sliding noise level: Less than 100mV)

Mechanical Specifications (Initial Value)

Mechanical specifications (Initial value)LSVA-1100 SeriesLSVA-6100 SeriesLSVA-4500 Series
Travel (Stroke) length100mm ±0.5mm60mm ±0.5mm45mm ±0.5mm
Operating force0 to 0.1N (Standard)
0.1 to 0.4N (High operating force)
Strength Nut-Attached100Ncm
Attached partsM3 screw (Length: Panel thickness + 3mm)
Stopper strength30N
Push-pull strength30N
Alignment to the center±0.5mm (State not to pressure control-bar, Measurement position: Mounting surface)

General Specifications

General specificationsLSVA Series
Temperature range-10 to +70 degrees C (Operating), -15 to +75 degrees C (Storage)
Relative humidity90%RH (No condensation)

REQUEST QUOTATION

PAYMENT

payment-methods

Return Top