Japan, Tokyo Ko-on Denpa
Tokyo Ko-on Denpa VP-1002A Series T-Bar Controller
Made in Japan
Manufacturer: Tokyo Ko-on Denpa Co., Ltd.
Model: VP-1002A Series
Features
Conductive plastic resistor element used (Low slide noise). 50mm control-bar.
Slide switch (at both ends ON) is optional.
Electrical Specifications
| Electrical specifications | VP-1002A Series |
|---|---|
| Products | VP-1002A*-** |
| Number of circuits / Type of output laws | 1 Linear taper |
| Circuit method | Potentiometer circuit |
| Total resistance (1-C) | 5kohm, 10kohm |
| Total resistance tolerance | ±20% |
| Linearity | ±5% |
| Residual resistance (1-2), (2-C) | 30ohm or less |
| Voltage proof | 1 Min. at AC500V |
| Insulation resistance | 50Mohm or more at DC500V |
| Max rating | 0.1W |
| Maximum input voltage | DC30V or less |
| Rated Resistive Load – Switch | DC30V 50mA |
| Sliding noise level | 47mV or less (by JIS C 6443) |
| Sliding life | 100,000 Cycles Min. (18cycles/min, Sliding noise level: Less than 100mV) |
Mechanical Specifications
| Mechanical specifications | VP1002A Series |
|---|---|
| Operating angle | 60 degrees ±1 degrees |
| Operating force | 0.3 to 0.5N |
| Stopper strength | 50N |
| Push-pull strength | 50N |
General Specifications
| General specifications | VP1002A Series |
|---|---|
| Temperature range | -10 to +70 degrees C (Operating), -15 to +75 degrees C (Storage) |
| Relative humidity | 90%RH (No condensation) |
Related Products
-
Vessel No.MA20S Socket Bit (Side Magnet)
-
Chiyoda Seiki KR-30H/KR-30H-H (Primary pressure: 15.0 MPa or less/adjustment pressure 0.5 to 3.0 MPa)
-
NAGANO KEIKI KH52 Differential Pressure Transmitter
-
UNIKA TP Type Taper Shank Drill Bit
-
Kondotec VXKW2 Series Shortening Pin Type Pewag Chain Sling
-
IMADA LC series High Accuracy Coin Shaped Load Cell
REQUEST QUOTATION
PAYMENT
LINK
