Japan, Kanetec
Kanetec No.5 Series Simple Magnetic Holder
Product Made in Japan
Manufacturer: Kanetec
Model: No.5 Series
Features
Simple holders consisting of an isotropic ferrite permanent magnet covered by an iron yoke. Dimensionally, the finishing accuracy is not good and these holders are not recommended for incorporation in jigs/fixtures. When these holders are used for the purpose of holding only by themselves, such purpose can be achieved at low cost.
Specifications
Round
| Model | Yoke Dimensions | Magnet Size | Magnet Type | Mass | Remarks | |||
|---|---|---|---|---|---|---|---|---|
| D₁ | H₁ | t | ||||||
| KM-FC2 | Ø18 (0.70) | 5 (0.19) | 0.8 (0.03) | Ø15 (0.59) × 4 (0.15) | 12.5g / 0.027lb | |||
| KM-FC4 | Ø24 (0.94) | 5 (0.20) | 0.55 (0.02) | Ø20 (0.78) × 4 (0.15) | Isotropic | 23.8g / 0.052lb | ||
| KM-FC5 | Ø31.6 (1.24) | 4.7 (0.18) | 0.8 (0.03) | Ø28 (1.10) × Ø5.5 (0.21) × 3.5 (0.13) | Isotropic | 38.2g / 0.084lb | ø4.3 hole provided | |
| KM-FC6 | Ø36 (1.41) | 7 (0.27) | 1.6 (0.06) | Ø30 (1.18) × 5 (0.19) | Isotropic | 97.5g / 0.214lb | ||
| KM-FC7 | Ø44 (1.73) | 10 (0.39) | 2 (0.08) | Ø38 (1.49) × Ø9 (0.35) × 5.7 (0.22) | Anisotropic | 122.5g / 0.270lb | M4 tapped hole provided | |
Rectangular
| Model | Yoke Dimensions | Magnet Size | Magnet Type | Mass | Remarks | |||
|---|---|---|---|---|---|---|---|---|
| L₁ | W₁ | H₁ | t | |||||
| KM-FK3 | 20 (0.78) | 34 (1.33) | 7 (0.27) | 1.6 (0.06) | 20 (0.78) × 30 (1.18) × 5 (0.19) | Isotropic | 51.4g / 0.113lb | |
| KM-FK5 | 55 (2.16) | 30 (1.18) | 8 (0.31) | 1.5 (0.05) | 49 (1.92) × 24 (0.94) × 6 (0.23) | Isotropic | 140g / 0.308lb | |
Dimensions
Related Products
-
Watanabe WGP-CTE CT converter (true RMS) – Signal Converter
-
Eagle Jack (Konno Corporation) LEVER-G100-200 Jack-Operated Lever
-
Kondotec Shackle With Pinstopper
-
TERAOKA SEISAKUSHO 6542 #25 Kapton(R) Film Adhesive Tape
-
Shimizu Flat Chisel – Hand Tools
-
Vessel No.GT-NY25-6 Sliding Air Nipper Horizontal-Type
