Japan, Kyowa Electronic Instruments Co., Ltd.
Kyowa LFX-A-1KN LFX-A Compact 6-component Force Transducer with Built-in Amplifier
Made in Japan
Manufacturer: Kyowa Electronic Instruments Co., Ltd.
Model: LFX-A-1KN
The LFX-A is a 6-component force transducer with built-in Amplifiers. It enables simultaneous measurement of 3 components of force (Fx, Fy, Fz) in 3 axial directions and 3 moments (Mx, My, Mz) around the axes. Hollowed structure for wiring easily.
Features
• Compact & lightweight
• Outputs 6 voltage signals proportionated to 6 detected components.
• Most suitable for reletively simple experments
Specifications
Performance
| Rated Capacity | Fx : ±1 kN Fy : ±1 kN Fz : ±1 kN Mx : ±40 N·m My : ±40 N·m Mz : ±25 N·m |
|---|---|
| Nonlinearity | Within ±0.5% RO |
| Hysteresis | Within ±0.5% RO |
| Interference | ±1.5% RO (After correction by interference compensated coefficients stated in the Test Data Sheet) *Output voltage signals of 6-component force should be compensated by using the interference compensated coefficients. The output interfere with each other. |
| Rated Output | Approx. 1500 mV (From 2500 mV output with no load at the center, after compensation) |
Environmental Characteristics
| Safe Temperature | -10 to 70ºC (Non-condensing) |
|---|---|
| Compensated Temperature | 0 to 60ºC (Non-condensing) |
| Temperature Effect on Zero | Within ±0.05% RO/ºC |
| Temperature Effect on Output | Within ±0.05%/ºC |
Electrical Characteristics
| No-load Output | 2500 mV at the center |
|---|---|
| Cutoff Frequencies of AMP | 500 Hz (Amplitude ratio at cutoff point -3 ±1dB) |
| Power Supply | 5 VDC ±10%, 160 mA or less |
| Cable | 16-conductor ( 0.08 mm2) twisted pair vinyl shielded cable, 6.6 mm diameter by 55 cm long, bared at the tip (9 conductors) (Shield wire is not connected to the case.)Signal Name······Coating color······Mark Fx····················Orange·············Red Fy····················Gray················Red Fz····················White···············Red Mx····················Orange············Black My····················Gray···············Black Mz····················White··············Black COM·················Blue DC+5V··············Red DC0V················Black Shield |
Mechanical Properties
| Safe Overloads | 150% |
|---|---|
| Materials | Main unit: Aluminum Cover: Black anode oxidized coated aluminum Cable holder: Anode oxidized coated aluminum |
| Weight | Approx. 210 g (Excluding cable) |
| Degree of Protection | IP40 (IEC 60529) |
| Other | The rated output, nonlinearity, hysteresis, and interference are the value at the time of load calibration on the moment center. * To obtain the rated output of ±1500 mV for each of 6-component force, zero drift due to installation conditions including tightening and loading should be made within ±200 mV. |
|---|
Dimensions
Related Products
-
SHIGEMATSU CDD01-S2-1 Dust Respirator
-
Chiyoda Tsusho Sleeve Connector Nipple
-
Kyowa KFGS 120 Ohm Uniaxial With Lead Wires From Both Ends KFGS Series General-Purpose Foil Strain Gages
-
Kitz 20SOB Ductile Iron 20K Swing Check Valve
-
Organo Olblaid A Series Anti-Corrosion And Scale Inhibitor
-
TONE ETW71 Electric Wheel Wrench (ETW70-Series) With Digitorqon
REQUEST QUOTATION
PAYMENT
LINK
