• We use RoHS2 compliant raw materials.
• There may be black spots (sludge) on the exterior.
• The remaining gate at the screw tip is less than 5% of the length (L).
• Please use in combination with a nut made of the same material as the thread pitch may shift during molding.
• If a nut is not used, the fit with the female thread should be 20 mm or less.

Features

• The values ​​in the table are reference values ​​and are not guaranteed values.
• Please use a torque driver and torque wrench for tightening. The recommended tightening torque is 50% of the breaking torque value under use.
• Heat resistance and chemical resistance vary depending on usage conditions, so be sure to test under usage conditions beforehand.
• There may be slight discoloration depending on the lot and various conditions.
• The washer may warp slightly.
• Inventory sizes, shapes, and manufacturers of materials used are subject to change without notice.