Japan, Shimizu
Shimizu Tile Joint Ruler for Rainwater and Sewage Basins
Made in Japan
Manufacturer: Shimizu Manufacturing Co., Ltd
Features
- You can easily mark tile cuts around rainwater and sewage troughs.
- The tile joint construction around the mass can be finished neatly in one shot.
- The diameter of pipes, round bars, etc. can be measured in one shot.
- The center of the end face of a round material can be taken in one shot.
- The center line of the end face of a round material can be drawn.
- With a ruler in the middle, you can measure joint width, tile thickness, etc.
Usage
- A ruler for marking tile cuts with a joint width of 4 mm when installing tiles around rainwater and sewage basins.
Corresponding Mass Nominal Diameter
200, 150, 125, 100, 75, 50 are supported.
How to use
1. Place the tiles on the squares where the tiles overlap, and mark the area where the outer diameter of the squares overlap with a pen or the like.
2. Next, place the ruler on the tile, align the mark with the line of the same diameter as the mass, and mark it with a pen or the like along the groove immediately above.
3. Cut the tiles according to the ruled lines.
*The joint width is basically 4 mm. If you want to increase the joint width, draw a line with a thick pen and cut it at the outer periphery of the line.
| part number | Product name | JAN code |
| 12072 | tile joint ruler | 309114 |
* Only the lower 6 digits of the JAN code are displayed (the upper 7 digits are 4960092)
Related Products
-
Kitz FT/FTS 5K Bronze Lift Check Valve
-
Murata T-shaped sleeve – 50014/50015/50015-A/50016-A
-
Fukudaco Siegling Transilon
-
Vessel No.TD-BS series Replacement Bit Set
-
Watanabe WVP-LM Signal limiting converter – Signal Converter
-
IMADA ZTS series (Separated Sensor Model) Standard Separated Sensor Model Digital Force Gauge
