Chemical, Isolite Insulating, Japan
Isolite Insulating Isowool Panel Heater
Manufacturer: Isolite Insulating
ISOWOOL PANEL HEATER
Features
Hybrid products with ISOWOOL VFSs and Heater Coils
PANEL HEATERs are hybrid products with ISOWOOL VFSs and Heater Coils. PANEL HEATERs, VFS heater panels with heater coils embedded in them are used for electric furnaces or for field stress relieving. These VFSs serve as both heat and electrical insulator. PANEL HEATERs are light weight, and have extreme stability at high temperature and high thermal insulation properties. PANEL HEATERs are formed together with heater coils under the suitable quality control at our plants. Following points are characteristics of PANEL HEATERs: 1. To be shorten assemble time of heater coils since light weight thermal insulator and heater coils can be install at one time. 2. To be shorten cycle time of furnace operation by the low heat storage and low thermal conductivity of PANEL HEATERs. 3. Various shapes of PANEL HEATER can be supplied not only flat panel and cylindrical shapes.
Typical Application
1. Heat treatment furnaces of metals
2. Diffusion furnaces of semiconductors
3. CVD furnaces
4. Experimental furnaces
5. Glass Heat Treatment Furnaces
Specifications and Shapes
| Max. Service temperature | 1200℃ | |
| Bulk density of VFS portion | 340kg/㎥ | |
| Standard thickness | Flat panel | 30～100mm |
| Other shapes | 25～50mm | |
| Typical heating capacity | 10～20kW/㎡ | |
| About higher heating capacity please ask our sales staffs. | ||
| Insulating Resistance | Over 5ＭΩ（room temp., measured voltage: 500V） | |
| Types | Embedded type is standard. ISOLITE can supply Embedded and Open type. Please ask our sales staffs about the types, sizes and shapes.
| |
Instructions and directions for use
1. Temperature measuring position
Temperature sensing parts, thermos couple should be fixed near heater coil due to prevent the overheating of the heater coil.
2. Usage in gas atmosphere
In case of usage in N2, NH3, SO2 gas or reducing gas such as CO, H2 gas atmosphere furnace, or vacuum furnace, the service temperature of the PANEL HEATER should be lower than usage in air atmosphere.
In case of usage in CO or hydrocarbon gas atmosphere, carbon, causing leak of electricity, may deposit and accrete on the PANEL HEATER.
Related Products
-
Okazaki Seiko SPSEE4A Coated Solid Carbide High Square Endmills (4 Flutes)
-
LOBTEX B-type The Optional Plate Sets ( Clamp (Standard Type))
-
SANYUTEC FM-Type Heavy Duty Mechanical Spline Shafted Type Universal Joint
-
OSC 92TP201 Altimeter (For Car)
-
Kunimoto For φ48.6 Tip Cap Missile For Single Tube
-
Murata Panzer mast/for concrete pillars 88030-1/88030-A1
