Japan, Kyowa Electronic Instruments Co., Ltd.
Kyowa EP-340Ambient curing or heat curing Glue
Made in Japan
Manufacturer: Kyowa Electronic Instruments Co., Ltd.
Model: EP-340Ambient curing or heat curing
In order to obtain good measurement data, the strain gauge must be fully bonded to the material under measure.
It is important to choose and use an adhesive that is suitable for the material to be measured, the material of the gauge base, and the measurement conditions.
*This is an external site.
Specification
type | Room temperature curing or heat curing |
---|---|
Operating temperature range | -55~150 |
Main applicable materials | ・Metals (iron, stainless steel, aluminum alloy, etc.) |
Hardening conditions | ・Pressurized (100±50kPa) at about 25°C for 24 hours or 80°C for 2 hours |
classification | Epoxy two-component mixed type |
capacity | 30g (6 bottles of 4g× main agent, 1 bottles of 5.4g× curing agent) |
forte | ・Suitable for bonding strain gauges in strain measurement up to the medium temperature range. |
Main applicable gauges | KFGS KFRB KFWB KFGT KFF KFSB KSNB(EXCLUDING E5) |
Remarks
Note: The operating temperature range is the adhesive itself and varies depending on the combination with the gauge. Before use, please read the attached instruction manual carefully before use.
Related Products
-
Kyowa USB-70B-20 External Scanner with NDIS4102 (7-pin) Connector for General Use UCAM-60C/65C Data Logger
-
Nakatani Kikai NG75L‐CR Die Grinder
-
SHOWA SOKKI Vibration Monitoring Wireless System
-
Kawasaki KPT IMPACT WRENCH For 1″ & 1-1/2″ sq.drive – Straight type
-
Naigai Ultra-Flexible SF Type (large diameter ) E-P Joint
-
Chiyoda Seiki TKR-2000P Series Large Flow/pilot Type Pressure Regulator (primary pressure: 20.0 MPa or less/adjustment pressure 0.2 to 1.5 MPa, standard flow rate: 900 m3/h・Air)