Japan, LOBTEX
LOBTEX TTH20 Manual Hydraulic Flanging Tool
Made in Japan
Manufacturer: LOBTEX CO., LTD.
Model: TTH20
For both flaring and flanging work
Applicable with new R410A coolant
・Enables quick flaring/swaging of a pipe, when the tip of the pipe is set in alignment with the gauge front surface.
・Compact design with a weight of 1,450 g.
・Rotating the tool 180° improves work efficiency.
Use/Application
Specifications
Model No. | (Product) weight | Set details | Use range | Retail/User prices | Remark |
---|---|---|---|---|---|
TTH20 | 3740g | HY20、TTH20G、HFR45、HTR13、HTR20 | (for Copper pipe):1/2″・5/8″ (for Flexible pipe):1/2″・3/4″ | open price | Metal case size:200×250×65mm |
IMPORTANT SAFETY INSTRUCTIONS
Before work, remove burrs from the pipe cut surface. If deburring is insufficient, inadequate processing may result. Remove burrs completely.
Tighten the gauge securely using the shaft included with the tool. If tightening is insufficient, the desired work surface may not be obtained.
Make sure that the gauge securely fits in the groove of the body yoke. If the gauge does not completely fit in the groove, it may come off during work.
CAUTIONS ON INSCRIBED VALUES
Since dimensions, weights, etc. are nominal, there possibly are changes of some numerical values.
Specifications may be changed for improvement of the product without prior notices.
Listed prices do not include VAT. Please ask our distributor in case of purchases.
Related Products
-
Super Tool HKLB7S/HKLB9S Long Arm Ball-Point Hex Key Wrench
-
Tosei Sharyo GLE Power Type Series Lifter
-
Eisen SRZ Series Limit Screw Gauge
-
Showa Measuring Instruments RCT-580 Special Transducers
-
Showa Measuring Instruments HVU Pressure Transducers
-
Chiyoda Seiki TKR-2000P Series Large Flow/pilot Type Pressure Regulator (primary pressure: 20.0 MPa or less/adjustment pressure 0.2 to 1.5 MPa, standard flow rate: 900 m3/h・Air)