,

SAN-EI SEIKI AGM Series Gear Turbine Type Air Motor

Made in Japan
Manufacturer: SAN-EI SEIKI SEISAKUSHO CO., LTD.
Model: AGM Series

Feature

  • Since a governor is equipped as standard, constant speed rotation can be obtained even if the load or pressure fluctuates. In addition, since a control handle is equipped as standard, the direction of rotation can be controlled by the motor. Please contact us for models that can be controlled by pilot pressure.
  • The standard exhaust port is horizontal, but you can connect the exhaust pipe by removing the cover.
  • There are no sliding parts other than the oil seal on the rotating part.
  • The output shaft can be rotated more lightly than the outside.
  • Either top (H1 in dimension table) or bottom (H in dimension table) mounting can be selected for the output shaft.

Structure

This motor incorporates a pair of gears in the case and is supported by bearings. The output shaft is taken out from this gear. The air supply side has a control valve for forward and reverse rotation and a governor for constant speed operation. The outer circumference of the motor has a structure that considers noise.

AGM Series

 

Note

  • A rotation speed of 1800 rpm is also available, so please specify when ordering. However, this number of rotations is the number of rotations at the maximum output. (Point A in the performance table on the right)
  • Please use the torque within the selection range shown in the figure on the right. Within this range, even if the load fluctuates, there is little change in the rotation speed.
  • In the figure on the right, T is the torque curve and L is the power curve. The horizontal axis represents the number of revolutions.

Specification comparison

*When air supply pressure is 0.5 MPa
modelOutput [kw]Rotation speed [rpm]Torque [Nm]Air consumption [㎥/min(nor)]
AGM107.51500488.5
AGM1511.615007513.5
AGM2318.8150011921.0
AGM4031.5150020035.0

REQUEST QUOTATION

PAYMENT

payment-methods

Return Top