Manufacturer: UNIKA
Model: E&S-DC (ST-shank)/ E&S-DC (SDS-shank)/E&S-DH For Hume Pipe (ST-shank)/E&S-DH For Hume Pipe (SDS-shank)

■Capable of drilling reinforced concrete (cutting up to triple-reinforcement) by dry process without using water.
■Center pin positions only to reduce vibration and noise.
■Uses “10 mm/13 mm chuck combination shank(PAT.P)” allowing most drill chucks.
■SDS shanks are also available at the same price.
◆Effective Length: Please refer to the spec table.
◆Matching drill: Electric drill/Percussion drill(rotating mode)
*Use water for cooling the cutting edge when drilling ceramic tiles and stone.

USES

Reinforced concrete•Hard exterior panel•Resin-bassed artificial marble•Mortar•Extruded cement plate•Soft exterior panel•Block•Brick•*Ceramic tile•Stone

■Handling Procedure

1. Align the center pin with the drilling position. Hold it tight and turn on the motor switch. [Rotation mode]
2. Stop the motor when the cutting edge is inserted approximately 5 mm and remove the center pin.
3. Lightly press the body against the drilling groove and continue operation.

■Cutting edge shape

PRECAUTIONS ON USE

SPECIFICATION

E&S-DC (ST-shank)

E&S-DC (SDS-shank)

E&S-DH For Hume Pipe (ST-shank)                                                         E&S-DH For Hume Pipe (SDS-shank)